Remove the roller assembly [D] Springs x2, Arms x2, Rollers x2 6. Assemble the PCU and install it in the machine. Replace the cleaning roller [F]. Continue to rotate the black gear until the developer is level. Open the developer pack [J] Replace the cleaning blade [A] x2 Reinstallation:
|Date Added:||22 December 2015|
|File Size:||5.40 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Attach the front frame pawls and front and rear [A].
I will warn you that it will most likely get messy. Follow the cautions below when handling a PCU. After the machine turns the development roller for 10 seconds, go to the next step.
Remove the rear screws [B] x2. Remove the top part [C] x1. If the holes are not aligned correctly, make sure that the tabs at the front, rear, and left side of the PCU are engaged correctly.
Open the right cover [A] and front cover [B]. Then push down lainer lock the tabs on the front and rear end of the PCU.
When the drum surface is touched or becomes dirty, wipe it with a dry cloth or clean it with wet cotton. Release the front tab [C]. Turn on the main power switch, and close the front door.
Replace the drum [E] White clip lznier [F]. Attached is a 3 page pdf of the settings and their values. Remove the rear shoulder screw [B] x1. Tighten the lower screw [E].
Set the bottom on the vinyl sheet. While continuing to turn the black gear, slowly move the pack left and right and pour the remaining half of the developer over the augur until the developer is level. Release the rear tab [D]. Turn the gears [G] to remove the developer from the bottom half. Install the PCU in the machine. Set the rear cover and front cover [B]. Tags for this Thread addresscablemachinenetworksettings.
Last updated on December 28, Replace the charge roller [E]. Do not lanidr developer on the gears or sponges. Therefore, I would recommend cleaning off a desk or work area ahead of time, organize your partsthen remove the PCU unit and take it over to the area where you will be working.
Network Connectivity – Have a MFC that’s lost it’s ability to communicate with the network after about 4 years. Lightly tap the top of the PCU [A] with a screwdriver at 8 locations.
Attach the side screw [G].
Turn on the main power switch. Turn the development roller gear [I] to remove toner from around the development roller.
Wipe with a dry cloth after cleaning with the cotton. Separate the top and bottom parts of the PCU. Tap 2 or 3 times at each location, to make the toner fall into the development section. These locations must be at equal intervals. You must be logged in to post a comment.