Fixing pressure roller cleaning Some LEDs leak a small amount of current even when normal, and therefore glow faintly even when they are off. The following is an example and explanation of what happens when you push 1 on the numeric keypad. However, if the nip width is not correct, faulty fixing may occur. Work details 6 While holding the knob, slowly pull the tape out. NO Reset the lever. Work details 1 Press the Data Registration Key to display the user mode screen.
|Date Added:||11 April 2013|
|File Size:||22.26 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
This activates the fan motor drive signal FAMONwhich cxnon turn raises the electrical voltage to the full speed levels, and full speed rotation of the fan begins. Developing Bias Control High voltage power supply circuit G3 bps Tx bps The power cord should not be disconnected at night.
Do not store in a location exposed to corrosive gases insecticides, etc. Do not store in an automobile for long periods of time. Looking for Supplies in the UK? The cartridge will perfectly fit for use for copying if placed in darkness for 5 minutes after exposure to 1,lux intensity light normal light for 5 minutes. The following label indicates that the product has been approved by the CDRH regulations.
During printing, the heater surface temperature setting is based on the following five conditions: Transmission modes set for 1touch dial or coded speed dial override service software switch settings. NO NO Priner the cassette properly. Bit setting Function 1 0 0 Reserved 1 Hp160 transmission echo protect tone 2 Reserved 3 Reserved 4 Transmission mode: However, do not expose the cartridge to direct sunlight.
Please press the set key on the control panel.
Adf Height Adjustment If the cartridge is shaken in a manner other than that described cabon, there is the danger that toner may leak from the developing assembly and cleaning assembly. When the paper roller rotates, the cams are also made to rotate, causing the lifter plate to rise, and the paper set in the multi-feeder comes into contact with multi-feeder pick-up roller.
This switch is only compatible with V machines. NO Replace the cartridge.
Do not use the other pinter patterns, as they are for factory and development use. And enters a plus sign when registering your fax number. In this case there are 2 types of timing which monitor the feeding situation.
Be sure not to touch or open the light-blocking shutter. Change this parameter before entering telephone numbers. Based on the scanning lamps drive signal LMPONwhich is output from the scanning lamp lighting control IC IC38the inverter PCB drive circuit comes into operation, causing 24V to be supplied to the scanning lamp via the scanning lamp lighting circuit.
Check pins not listed below are only for factory use, and their adjustment and check requires special tools and measurement instruments.
Report display function settings SW No. Is the trouble caused by wear, abrasion or cracking on the pick-up roller surface? A sudden rise in temperature of the fixing heater end may occur if small-sized paper is used when printing at dpi. Pick-up roller Feed roller Separation roller Registration roller 4 5 Is the registration roller normal?
Check from Item 7. If it is not possible to replace this thermoswitch, or pdinter the switch has tripped because the temperature does not return to normal, eliminate the cause of the temperature increase, and then replace the image processor PCB. Is it 1 YES Clean the paper feed dirty?